Micro-Raman Assessment of the Ratio of Carbon-Carbon Double Bonds of Two Adhesive Systems Cured with LED or Halogen Light-curing Units

Purpose: The purpose of the study was to compare the ratio of carbon-carbon double bonds (RDB) of two adhesive systems cured by five different light-curing units (LCUs) using micro-Raman spectroscopy. Materials and Methods: Ten samples of an etch-and-rinse (Excite), a two-step self-etching adhesive system (AdheSE) - ie, primer and bond mixed - and AdheSE Bond only were prepared and cured with one of the following LEDs: Elipar Freelight2; Bluephase; SmartLite; Coltolux, each for 10 s; or a conventional halogen Prismetics Lite for 10 s or 20 s. Micro-Raman spectra were obtained from uncured and cured samples of all three groups to calculate the RDB. Data were statistically analyzed using ANOVA. Results: The mean RDB values were 62% to 76% (Excite), 36% to 50% (AdheSE Primer+Bond) and 58% to 63% (AdheSE Bond). At 20 s, Prismetics Lite produced significantly higher RDB in Excite than the other LCUs and Prismetics Lite at 10 s (p 0.05). Prismetics Lite at 20 s and Elipar produced comparable RDB values of AdheSE Bond and AdheSE Primer+Bond (p > 0.05). Excite showed significantly higher RDB values than AdheSE (p 0.05) whilst AdheSE Bond showed significantly higher RDB than AdheSE Primer+Bond (p 0.05). Conclusion: The etch-and-rinse adhesive cured with the halogen LCU for 20 s gave higher conversion than LED LCUs or halogen for 10 s curing time. The highest intensity LED [Elipar] produced higher or comparable conversion compared to the lower intensity LED LCUs for the same curing time. The etch-and-rinse adhesive showed higher RDB than the self-etching adhesive system. The presence of the primer in the self-etching adhesive compromised polymerisation. Schlagwörter: micro-Raman spectroscopy, adhesive systems, degree of conversion, light curing units