Quintessence International, 03/2016

Objectives: To investigate the marginal accuracy of Cerec three-dimensional (3D) all-ceramic crowns, in terms of gap and overhang, and to analyze the "operators' experience" and "cement space" effects on the marginal fit. Method and Materials: Thirty virtual models were obtained from a metal master die by scanning by three different operators: operator 1 (novice), operator 2 (beginner), and operator 3 (expert) (n = 10). These were further divided into two subgroups of five each, based on the cement space settings: 10 μm and 20 μm. Monolithic ceramic crowns (n = 10) were designed and milled for each virtual model and subjected to marginal gap and overhang evaluation at six designated margin locations. The influence of operators' experience and cement space on the marginal fit of the crowns was assessed by performing Box tests and MANOVA (multiple analysis of variance) (α = .05). Kruskal Wallis test was also used to analyze the interactions between the operators' experience and the cement space. Results: The overall mean ± SD marginal gaps and overhangs for the Cerec 3D crowns, were 154 ± 56 μm and 74 ± 74 μm for novice, 158 ± 53 μm and 86 ± 66 μm for beginner, and 155 ± 52 μm and 47 ± 76 μm for expert, respectively. The MANOVA and Kruskal Wallis tests found no significant differences (P > .05) between the operators, in terms of gap and overhang, for all cement settings. Conclusion: The operator experience did not seem to influence the marginal accuracy of Cerec 3D fabricated crowns. Keywords: Cerec, ceramic, crown, digital, marginal fit

Objective: The correlation between periodontal status and systemic conditions, among them pregnancy, is widely described in the scientific literature. The aim of the present systematic review of the literature was to evaluate periodontal diseases as an independent risk factor for adverse pregnancy outcomes. Data: Case-control studies reporting pregnancy outcomes and periodontal status of the subjects were included. Risk of bias evaluation was performed using a tool developed by the Cochrane Bias Methods Group. After risk of bias evaluation of included studies, a meta-analysis was performed computing the Risk Ratio (RR) for each pregnancy outcome. Sources: Electronic databases (MedLine, Embase, Cochrane Central) were searched after preparation of an appropriate search string. Study selection: The search resulted in 422 entries that were screened. After application of inclusion and exclusion criteria, a total of 22 studies were included in the review accounting for a total of 17,053 subjects. The computed RR for periodontitis was 1.61 for preterm birth evaluated in 16 studies (P .001), 1.65 for low birthweight evaluated in 10 studies (P .001), and 3.44 for preterm low birthweight evaluated in four studies. Conclusion: The present systematic review reported a low but existing association between periodontitis and adverse pregnancy outcomes. This assumption is the result of proper corrections of biased methodologies and of heterogeneity of studies. ( Keywords: adverse pregnancy outcomes, meta-analysis, periodontal diseases, periodontitis, risk factor

Minimally invasive treatment options have become increasingly feasible in restorative dentistry, due to the introduction of the adhesive technique in combination with restorative materials featuring translucent properties similar to those of natural teeth. Mechanical anchoring of restorations via conventional cementation represents a predominantly subtractive treatment approach that is gradually being superseded by a primarily defect-oriented additive method in prosthodontics. Modifications of conventional treatment procedures have led to the development of an economical approach to the removal of healthy tooth structure. This is possible because the planned treatment outcome is defined in a wax-up before the treatment is commenced and this wax-up is subsequently used as a reference during tooth preparation. Similarly, resin- bonded FDPs and implants have made it possible to preserve the natural tooth structure of potential abutment teeth. This report describes a number of clinical cases to demonstrate the principles of modern prosthetic treatment strategies and discusses these approaches in the context of minimally invasive prosthetic dentistry. Keywords: adhesive technique, all-ceramics, diagnostic template, high-density polymers, minimally invasive preparation, occlusal onlays, resin-bonded FDPs, veneers, wax-up

Objective: The technique of local anesthetic administration is an important consideration in the behavior guidance of a pediatric patient. The study hypothesized that there is no difference in the pain effectiveness in the experimental subjects with the use of single tooth anesthesia and the controls with the use of conventional technique (traditional inferior alveolar nerve block [IANB]).The purpose of this study was to compare the anesthesia effectiveness of traditional IANB; IANB using a computer-controlled local anesthetic delivery system (CCLAD); and intraligamental anesthesia (ILA) using CCLAD in pulpotomy of the primary mandibular second molars. Method and Materials: Ninety-one healthy 5- to 9-year-old children underwent pulpotomy of the mandibular second molars. They were randomly assigned into Group A (traditional IANB), Group B (IANB using CCLAD), or Group C (ILA injection using CCLAD). The effectiveness of anesthesia was measured during different steps of pulpotomy using the sounds, eyes, and motor (SEM) scale. The postoperative complications were recorded after 24 hours. Results: For all five pulpotomy steps, the anesthesia effectiveness was similar among the three anesthesia techniques. Anesthesia effectiveness was not significantly different (based on SEM scores) between the three groups during clamp application, drilling of the tooth, entering the pulp, pulp extirpation, and removal of the clamp (P = .635, P = .996, P = .630, P = .945, and P = .101, respectively). There was no significant difference in postoperative complications between the three groups. Conclusion: The IANB anesthesia using CCLAD and periodontal ligament anesthesia using CCLAD were as effective as traditional IANB in anesthetizing the primary mandibular molars during pulpotomy. Keywords: anesthesia, computerized, effectiveness, mandibular, primary molars, pulpotomy

Removal of third molars is a common surgical procedure with low complication rates. Localized alveolar osteitis, infection, bleeding, and paresthesia are the four most common postoperative complications of third molar extraction reported in the literature. Postoperative severe hemorrhages are rare and are usually related to inferior alveolar artery damage. Although most bleeding is usually managed effectively by local compression or packing of the socket, even life-threatening complications may occur. Endovascular embolization has been rarely reported as treatment for such a complication and represents an ideal solution, with a low complication rate and excellent control of bleeding. The authors report a case of potentially life-threatening hemorrhage continuing 4 days after extraction of the mandibular right third molar, resulting in significant anemia (Hb 6.6 g/dL) and treated successfully with endovascular embolization of the inferior alveolar artery. The authors consider it important for general practitioners to know this treatment and how to manage this rare complication in the correct way, saving time if satisfactory hemostasis cannot be reached with common procedures. Keywords: alveolar artery bleeding, endovascular embolization, extraction complication, inferior alveolar artery

Achieving predictable guided bone regeneration in critical size defects for future endosseous dental implant therapy poses a great challenge to clinicians. A novel technique utilizing autogenous osteogenic progenitor cells, calcium sulfate activated platelet-rich plasma in addition to particulate allograft was successfully used to augment a severely deficient maxillary anterior edentulous ridge. After 6 months of healing, satisfactory radiographic and clinical bone gain was noted with significant increase in alveolar ridge width. Endosseous implants were placed and restored successfully. The techniques with underlying clinical and biologic rationales are presented and discussed in this report. Keywords: bone augmentation, dental implant, edentulism, platelet-rich plasma, ridge augmentation

Despite the common prevalence of cutaneous psoriasis, the existence of manifestations in the oral cavity is subject to controversy. In this article, dermatologic psoriasis is reviewed, and a patient with generalized, symptomatic oral mucosal erythema resembling atrophic candidiasis synchronous with flare of chronic skin psoriasis is described. Diagnostic work up and therapeutic response supported that these mucosal findings were the oral counterpart of cutaneous disease. Dental providers should be familiar with the signs and symptoms of oral psoriasis, institute appropriate preventive measures, and provide palliation directed at symptomatic oral changes of psoriasis. Keywords: oral, psoriasis

Objective: Dental restorations may be plaque retentive. The aim of this study was to evaluate the long-term association between proximal restorations and the incidence and progression of periodontal disease in well-maintained patients. Method and Materials: Probing pocket depths (PPD), bleeding on probing (BOP), and radiographic status of proximal restorations were retrospectively retrieved from files of patients attending a specialist periodontal office. Ill-fitting margins were recorded. The association between these parameters was evaluated at baseline examination (T0), after cause-related therapy (T1) and after ≥ 10 years from T0 (T2), during which supportive periodontal therapy (SPT) was administered, using descriptive statistics, ANOVA-Bonferroni, and chi-square analyses. Results: 1,301 teeth were examined. Mean PPD in unrestored surfaces was 3.7 ± 1.7 mm, 3.1 ± 1.3 mm, and 2.8 ± 1 mm at T0, T1, and T2, respectively. Deeper pockets were found in restored surfaces at those time points with PPD values of 4.4 ± 1.8 mm, 3.6 ± 1.4 mm, and 3.2 ± 1.1 mm, respectively (P .001). Higher PPD values were found in restored surfaces exhibiting inadequate restorations when compared to restored surfaces with adequate restorations at all time points. These values were 4.9 ± 1.9 mm, 4.1 ± 1.5 mm, and 4 ± 1.7 mm vs 4.3 ± 1.8 mm, 3.6 ± 1.4 mm, and 3.1 ± 1.1 mm, respectively (P .001). Conclusion: The present study confirmed that restorations might be detrimental to periodontal health. A significant association between the presence of proximal restorations and the incidence of periodontal disease was observed. This association was more pronounced for inadequate restorations while becoming less significant over time in patients receiving routine SPT. Keywords: dental restorations, longitudinal study, periodontal disease