Pages 365-370, Language: EnglishCheylan, Jean-Marie / Gonthier, Samuel / Degrange, MichelPurpose: New luting agents, described as resin-modified glass-ionomer cements and compomers, have been developed during the last decade to improve the retention of cemented restorations. The aims of this study were to (1) compare the push-out strength of these new luting materials against both conventional cements and bonding luting agents, and (2) evaluate the influence of dentin surface treatment on both glass-ionomer cement and 4-META adhesive resin push-out strength.
Materials and Methods: Conical standardized cavities were drilled in the center of coronal dentin disks. Ninety sandblasted Ni-Cr inlays, divided into nine batches, were luted into the cavities according to the surface treatment and the nature of the following luting agents: zinc phosphate cement, zinc polycarboxylate cement, type I glass-ionomer ± polyacrylic acid, resin-modified glass-ionomer, polyacid-modified composite resin, filled bis-GMA phosphate ester resin, and 4-META adhesive resin ± application of activated monomer. Each specimen was placed in a holding device, and a steel rod was used to apply a force on the inlay until rupture occurred. The push-out strength was calculated, and the failure mode was controlled.
Results: There were significant differences between some of the groups. The highest push-out strength was achieved by the 4-META adhesive resin after application of activated monomer. The lowest value was attained with zinc phosphate and polycarboxylate cements.
Conclusion: Both resin-modified glass-ionomer and polyacid-modified composite resin luting materials exhibited a push-out strength similar to resin-based materials. Specific dentin surface treatments significantly enhanced the push-out strengths of glass-ionomer cement and 4-META adhesive resin.