DOI: 10.3290/j.jad.a41308, PubMed ID (PMID): 30349906Pages 417-424, Language: EnglishDurgesh, Bangalore H. / Alkheraif, Abdulaziz A. / Musaibah, Abobaker Salem / Asiry, Moshabab A. / Varrela, Juha / Vallittu, Pekka K.Purpose: The present study investigated the creep of adhesive resin under constant loading at the orthodontic bracket/enamel interface with an orthodontic bracket-tooth model (shear creep) and three-point bending test (bending creep).
Materials and Methods: For the bracket-tooth model, sixty premolars were assigned to 4 groups (n = 15). Orthodontic brackets were bonded onto the enamel surface using four different bonding agents: conventional, homogeneous Transbond XT orthodontic composite (group 1/TBC); Transbond XT composite reinforced with photopolymerized glass-fiber-reinforced composite (FRC with bidirectional fibers) (group 2/TBE); Transbond XT reinforced with FRC of vertically oriented unidirectional fibers (group 3/TBV); and Transbond XT reinforced with FRC of horizontally oriented fibers (group 4/TBH). Load was applied at the bracket/tooth interface and from the bracket wire slot. In the three-point bending test, the creep and recovery of the rectangular interface materials were tested by a dynamic mechanical analyzer. The data obtained were statistically analyzed with ANOVA and a post-hoc test using SPSS v20 statistical software.
Results: The groups exhibited significant differences in strain % and time for bracket deflection at the interface (p 0.05). The interface loading with unidirectional fibers (groups TBV and TBH) were statistically significantly different compared to the interface with bidirectional fibers and control group (groups TBE and TBC). The three-point test showed the least creep compliance (ie, creep deformation occurring at each time point [J]) with group TBC, followed by groups TBV and TBE. Group TBC showed the highest nanohardness and elastic modulus; the lowest values were seen in group TBE, reflecting differences in polymer matrix composition.
Conclusion: The creep and time for debonding the bracket increased with incorporation of glass fibers at the interface between bracket and enamel.
Keywords: adhesive resin, fiber reinforced composites, interpenetrating polymer network, cross linking, creep, recovery
