Purpose: To investigate the influence of occlusal interference using finite element analysis (FEA).
Materials and Methods: The FEA model designed for this study centered on an all-ceramic, bilayered, fixed partial denture (FPD) retained on its maxillary first premolar and first molar, with the second premolar replaced by a pontic. The surrounding structures – such as the neighboring teeth, antagonists, and periodontium – were modeled. Four different loading cases were designed at occlusal interferences of 0, 8, 12, and 24 µm and were loaded by a simulated bite force of 300 N. Principal and Von Mises stresses, as well as strain, were evaluated for all included structures.
Results: For interferences of 12 and 24 µm, failure-relevant tensile stresses in the veneering later were observed at the occlusal surfaces. Stress found in the zirconia FPD did not reach fatigue or flexural strength for any test load.
Conclusion: Peak tensile stress was observed in close proximity to occlusal contact points, increasing with increasing occlusal interference. The FEA results suggest that the majority of occlusal stress is absorbed by the deformation of the periodontal ligament. Framework failure caused by the simulated interferences was not expected. Surface defects may ultimately lead to failure due to fracture or chipping, especially in cases of weaker ceramics or veneering.