Cerec Omnicam and the Virtual Articulator - A Case Report

This case report demonstrates how two opposing teeth were restored with full crowns using Cerec software version 4.2 (pre-release version). In addition, an anterior tooth was provided with a veneer. The situation was scanned with the Cerec Omnicam. The new virtual articulator was used for the design to obtain correct dynamic contacts. The Cerec Omnicam can scan the entire situation prior to preparation without the help of an assistant, as no surface pretreatment is necessary. The locations of the occlusal contacts can be marked with articulating paper and are indicated on the virtual models. Selective deletion of individual areas allows the prepared teeth to be rescanned, considerably speeding up the workflow. A video demonstration is available of the acquisition and design procedure. Keywords: Cerec, Omnicam, virtual articulator, virtual model, veneer, crown, lithium disilicate