Purpose: To investigate dentin abrasivity and cleaning efficacy of novel/alternative toothpastes containing diamond particles, active carbon, sea salt or organic oils. Materials and Methods: Seventy-two bovine dentin samples (for measuring abrasivity) and 60 human dentin samples (for assessing cleaning efficacy) were used in this study. Samples were divided into six groups as follows: group 1: Elmex Kariesschutz (hydrated silica); group 2: Lavera Neutral Zahngel (sea salt); group 3: Curaprox Black is White (active carbon); group 4: Swiss Smile Diamond Glow (diamond powder); group 5: Ringana Fresh Tooth Oil (hydrated silica); and group 6: artificial saliva. Samples were brushed for a total of 26 min at 120 strokes/min, replacing slurries (1 part respective toothpaste and 2 parts artificial saliva) every 2 min. Finally, abrasive dentin wear was measured profilometrically and cleaning efficacy planimetrically. Results: The highest abrasivity values were observed for Lavera Neutral Zahngel (sea salt 9.2 µm) and Elmex Kariesschutz group (hydrated silica 6.0 µm). The lowest abrasivity value was observed for Ringana Fresh Tooth Oil group (hydrated silica 1.3 µm). The highest cleaning efficacy was observed for Elmex Kariesschutz group (86.7%) and the lowest cleaning efficacy was observed for Ringana Fresh Tooth Oil group (31.3%). Conclusion: The addition of diamond powder or active carbon to toothpastes could offer high cleaning efficacy with low dentin abrasivity. The addition of sea salt to traditional abrasives might cause high abrasive dentin wear without adding further cleaning benefit. Schlagwörter: abrasive dentin wear, active carbon, alternative toothpastes, diamond powder, toothpaste abrasivity