Purpose: Evaluating the facial esthetics of complete denture (CD) treatment using a 3D analysis of the lower third of the face before (T1) and after (T2) treatment by comparing and correlating measurements. Material and Methods: Thirty-one edentulous patients were enrolled, and three-dimensional (3D) images were captured before (T1) and after (T2) CD delivery. Twelve landmarks were established in the face. Linear, angular, surface, and perimeter measurements were evaluated and compared with the paired t test. The delta (Δ) values (T2-T1) were assessed by the Spearman correlation to verify the associations between all measurements according to the facial parameters (α=.05). Results: Statistical differences were identified in the lower third of the face in the linear measurement Sn-Gn (P = 0.006), the angular measure Tright-Pg-Tleft (P = 0.004), and at the surface of the lower third of the face (P = 0.001). All measurements were statistically different in the labial protrusion area: the nasolabial angle (Prn-Sn-Ls), the surface, and the perimeter (P = 0.001). In the lip evaluation, statistical differences were observed in the linear (Ls-Li), surface, and perimeter measurements (P = 0.001). Conclusion: The facial esthetic proportions of the linear and perimeter measurements increased, and the angles of sealed lips and nasolabial and lower facial convexity decreased after CD delivery. The present study showed a clinical important correlation between linear and angular measurements that should help restore facial esthetics, providing metrics that can aid the clinician in facial composition.