Bond Strength of a Flowable Bulk-fill Resin Composite in Class II MOD Cavities

Purpose: To evaluate the microtensile bond strength (μTBS) of a bulk-fill low-stress resin-based composite to dentin from gingival walls of Class II MOD cavities. Materials and Methods: Class II MOD cavities were prepared in 44 human molars with the distal and mesial proximal boxes 4 and 6 mm deep, respectively. Eight experimental groups (n = 11) were obtained by a factorial design including 1. "composite" in two levels: a bulk-fill low-stress composite (SureFil SDR Flow, Dentsply Caulk) and a conventional composite (Filtek Z350 XT, 3M ESPE); 2. "filling technique" in two levels: bulk-fill (Bf) and incremental (In); and 3. "depth" in two levels: 4 mm and 6 mm in order to create different polymerization conditions. Twenty-four hours after placement of restorations, teeth were sectioned into beams with a cross-sectional bonded area of approximately 1 mm2. Bonded beams obtained from the gingival walls of the proximal boxes were tested in tension at a crosshead speed of 1 mm/min. Data were submitted to a 3-way ANOVA followed by a post-hoc Tukey's test (p 0.05). Results: ANOVA failed to identify significant differences for the triple and double interaction between factors. However, significant differences were observed for the factors "composite" and "filling technique" (p 0.05). SDR presented significantly higher μTBS values for bulk and incremental filling techniques (p 0.05), and the incremental filling technique presented significantly higher μTBS values for both composites (p 0.05). Conclusion: It can be concluded that the bulk-fill flowable composite SDR may improve the bond strength to the gingival walls of Class II MOD cavities. Parole chiave: tensile strength, bulk-fill composite, filling technique