This study evaluated a panel of clinical, dimensional, volumetric, implant-related, histomorphometric, and patient-reported outcome measures (PROMs) following reconstruction of dehiscence defects in extraction sockets with a minimally invasive technique using particulate bone allograft and a nonresorbable dense polytetrafluoroethylene (dPTFE) membrane. Subjects (n = 17) presenting severe buccal dehiscence defects at the time of single-rooted tooth extraction participated in the study. The mean vertical dimension of the dehiscence defects at baseline was 5.76 ± 4.23 mm. Subjects were followed up at 1, 2, 5, and 20 weeks postoperatively. The dPTFE barrier was gently removed at 5 weeks. CBCT and intraoral scans were obtained at baseline and at 20 weeks. A bone core biopsy sample was harvested at 24 weeks (before implant placement). Linear radiographic measurements revealed a mean increase in buccal bone height from baseline to 20 weeks (5.66 ± 5.1 mm; P < .0001). A total alveolar bone volume gain of 9.12% was observed. Although approximately half of the sites required some degree of additional bone augmentation at the time of implant placement, all implants were placed in a favorable restorative position with adequate primary stability. Histomorphometric analyses revealed a mean mineralized tissue area of 31.04% ± 15.22%, and the proportions of remaining allograft material and nonmineralized tissue were 16.23% ± 10.63% and 52.71% ± 9.53%, respectively. All implants survived up to 12 months after placement. PROMs were compatible with minimal discomfort at different postoperative stages and a high level of overall satisfaction upon study completion. This study demonstrated that the reconstructive procedure employed was successful and predictable in treating large, postextraction alveolar ridge deformities to optimize tooth replacement therapy with implant-supported prostheses.
