Quintessence International, 04/2024

Objectives: The objective was to evaluate the polymerization efficiency of different bulk-fill resin-based composites cured by monowave and polywave light-curing units, by assessment of the degree of conversion and Vickers microhardness at different depths. Method and materials: Two commercially available bulk-fill resin-based composites were used: Filtek One Bulk Fill Restorative (3M ESPE) and Tetric N-Ceram Bulk Fill (Ivoclar Vivadent). The light-curing units utilized were two LED light-curing units: a monowave LED light-curing unit (BlueLEX LD-105, Monitex) and a polywave LED light-curing unit (Twin Wave GT-2000, Monitex). For each test, 20 cylindrical specimens (4 mm diameter, 4 mm thickness) were prepared from each bulk-fill resin-based composite using a split Teflon mold. Ten specimens were light-cured by the monowave light-curing unit and the other ten were light-cured by the polywave light-curing unit according to the manufacturer’s recommendations. Attenuated total reflectance-Fourier transform infrared spectroscopy (ATR-FTIR) was used to assess the degree of conversion, and a Vickers microhardness tester was used to assess Vickers microhardness. Statistical analysis was performed using three-way ANOVA and Tukey post-hoc tests (P < .05). Results: The degree of conversion and Vickers microhardness in bulk-fill resin-based composites containing only camphorquinone as photoinitiator were similar when cured with either monowave or polywave light-curing units. However, bulk-fill resin-based composites containing a combination of photoinitiators exhibited significantly higher degree of conversion and Vickers microhardness when cured with a polywave light-curing unit. Although all groups showed statistically significant differences between the top and bottom surfaces regarding degree of conversion and Vickers microhardness, all of them showed bottom/top ratios > 80% regarding degree of conversion and Vickers microhardness. Conclusion: The polywave light-curing unit enhanced the polymerization efficiency of bulk-fill resin-based composites especially when the latter contained a combination of photoinitiators, but does not prevent the use of a monowave light-curing unit. Schlagwörter: bulk-fill resin-based composite, degree of conversion, light-curing unit, photoinitiator, Vickers microhardness

Objective: Polycystic ovary syndrome (PCOS) is widely reported among young females, and anti-androgens are used for treating hirsutism and acne in these patients. The protective effects of myo-inositol, oral contraceptives, and insulin sensitizers have been reported on the periodontium and high-sensitivity C-reactive protein (hsCRP) levels in PCOS females. However, cyproterone acetate/ethinyl estradiol (CPA/EE) has not yet been studied. This cross-sectional study explores the periodontal status and systemic inflammation in PCOS women on CPA/EE drug combination compared to females not on medication. Method and materials: A total of 150 participants were enrolled into three groups: 50 newly diagnosed PCOS females not on medication (N-PCOS); 50 PCOS females consuming CPA/EE combination for the last 6 months (PCOS+CPA/EE); and 50 systemically healthy females (control group). Anthropometric, biochemical, periodontal parameters, and health-related quality of life questionnaires were recorded. Results: N-PCOS and PCOS+CPA/EE groups showed a nonsignificant difference in hsCRP levels, Gingival Index, bleeding on probing, waist circumference, and waist–hip ratio (P > .05). Gingival thickness and keratinized tissue width were significantly greater in the PCOS+CPA/EE than the N-PCOS group (P ≤ .05); however, these were comparable with the control group (P > .05). Regression analysis showed significant association of bleeding on probing with Gingival Index, clinical attachment level, and hsCRP (P ≤ .05). Conclusions: CPA/EE combination does not influence the periodontal and systemic inflammatory status in PCOS females, as similar levels of local and systemic inflammation were observed in CPA/EE consumers compared with PCOS females not on medication. However, it might play a role in increasing gingival thickness and keratinized tissue width in these patients. Schlagwörter: C-reactive protein, cyproterone acetate/ethinyl estradiol drug combination, gingivitis, periodontitis, phenotype, polycystic ovary syndrome

This clinical case outlines a comprehensive digital workflow for a minimally invasive multidisciplinary treatment. The process utilizes one open-source software for digital wax-up and one low-cost software to address esthetic concerns related to teeth misalignment. The patient’s function was stabilized with a digitally made occlusal splint. The application of the described digital workflow technique, incorporating open-source, low-cost, and closed software, played a pivotal role in attaining a straightforward and predictable outcome with minimally invasive treatment. Furthermore, the continual evolution of technology contributes to the growing precision of dental procedures. The presented digital workflow helped formulate a predictable treatment plan, replicate a diagnostic digital wax-up, and achieve precise teeth alignment. This approach satisfactorily addressed the patient’s esthetic concerns, providing an outstanding approximation of the definitive result. Schlagwörter: close software, digital workflow, low-cost software, open-source software, wax-up

Objective: This retrospective study analyzed radiographic bone levels of 10,871 dental implants in a cohort of 4,247 patients over a 22-year period. The objectives of the study were to assess and explore risk factors associated with the radiographic bone level of dental implants. Method and materials: A longitudinal observational cohort study based on data collected from 1995 to 2019 was conducted on implants placed by a single periodontist. Inclusion criteria included both partially and fully edentulous sites. Exclusion criteria were patients who were considered ASA 3 or greater. Information on medical and dental status prior to implant placement such as diabetes and smoking were included in the analysis. Implant factors such as the implant characteristics (length and diameter) and surgical site were recorded. The outcome assessed was the prevalence of bone loss around implants and any associative factors related to the bone loss. Results: Overall, dental implants lost an average of 0.05 ± 0.38 mm of bone 2 to 3 years after placement and 0.21 ± 0.64 mm 8 years after placement. The soft tissue condition was evaluated using the Implant Mucosal Index (IMI), and bone loss around dental implants was significantly higher when bleeding on probing was multi-point and moderate, multi-point and profuse, and when infection with suppuration was recorded. The mean difference in bone level between smokers and nonsmokers was 0.26 mm (P < .01) over a 4-year period. A mean difference of 0.10 mm (P = .04) in bone loss over 4 years was found between those with an autoimmune disease compared to those without. The diameter of the implant and immediate loading of the dental implant did not influence the radiographic bone levels over time. Conclusions: This large dataset of dental implants highlights predictive risk factors for bone loss around dental implants and the impact these risk factors have on the implant bone level. Consideration of these risk factors by both the dental team and the patient prior to dental implant placement will promote success of the treatment. Schlagwörter: diagnostics, implants, peri-implantitis, radiograph, success, survival

Objective: The evidence base for the use of space maintainers is relatively sparce despite being used for decades after the premature loss of primary molars. This study aims to increase the dental evidence base via investigating retrospectively the success rates of prefabricated fixed and removable space maintainers inserted from 2019 to 2021 and followed up until February 2023 at a specialized university clinic and to identify reasons for any reported minor and major failure. The authors hypothesized that there is no significant difference in failure rates between fixed and removable space maintainers inserted after the premature loss of a single primary molar per quadrant. Method and materials: Patients’ digital records were searched yielding 645 space maintainers. After the application of inclusion criteria, 157 (67%) fixed prefabricated space maintainers in 112 children and 77 (33%) removable space maintainers in 61 children were analyzed for an average of 18.4 ± 9.5 months. Results: Kaplan–Meier survival analysis with Mantel–Cox statistics showed an overall cumulative survival time of 31.6 months (SE = 1.15, 95% CI = 29.4 to 33.9). Major failure occurred significantly more in removable maintainers (n = 40/67, 59.7%), mostly due to loss of the appliance, compared to fixed space maintainers (n = 27/67, 40.3%; P < .001). The present study indicates that space maintainers were mainly placed in young children with high caries experience, where treatment was mostly possible using advanced behavior management. Conclusions: Fixed space maintainers had a significantly lower failure rate than their removable counterpart. However, both require continual repairs, preservation, or even replacement till the eruption of the permanent tooth. Schlagwörter: band and loop, failure rate, removable appliance, space maintainer, survival rate

Objectives: This case series aimed to assess the efficacy of a novel horizontal ridge augmentation modality using histology. Combinations of “sticky bone” and tenting screws without autologous bone were used as augmentative materials. Method and materials: Five individuals presenting healed, atrophic, partially edentulous sites that required horizontal bone augmentation before implant placement were enrolled. Patients underwent the same augmentation type and 5 months of postoperative reentry procedures. The first surgery served as implant site development, whereas the biopsy and corresponding implant placement were performed during reentry. The bone was qualitatively analyzed using histology and histomorphometry and quantitatively evaluated using CBCT. Results: Four individuals healed uneventfully. Early wound dehiscence occurred in one case. Histology showed favorable bone substitute incorporation into the newly formed bone and intimate contact between de novo bone and graft material in most cases. Histomorphometry revealed an average of 48 ± 28% newly formed bone, 19 ± 13% graft material, and 33 ± 26% soft tissue components. The CBCT-based mean alveolar ridge horizontal increase was 3.9 ± 0.6 mm at 5 months postoperatively. Conclusions: The described augmentation method appears suitable for implant site development resulting in favorable bone quality according to histology. However, clinicians must accommodate 1 to 2 mm of resorption in augmentative material width at the buccal aspect. Schlagwörter: autologous platelet concentrates, histology, histomorphometry, horizontal augmentation, sticky bone, tenting screw

Objective: This study aimed to evaluate the effectiveness of biomaterials in bone healing of critical bone defects created by piezoelectric surgery in rat calvaria. Method and materials: Histomorphologic analysis was performed to assess bone regeneration and tissue response. Fifty animals were randomized into five groups with one of the following treatments: Control group (n = 10), spontaneous blood clot formation with no bone fill; BO group (Bio-Oss, Geistlich Pharma; n = 10), defects were filled with bovine medullary bone substitute; BF group (Bonefill, Bionnovation; n = 10), defects were filled with bovine cortical bone substitute; hydroxyapatite group (n = 10), defects were filled with hydroxyapatite; calcium sulfate group (n = 10), defects were filled with calcium sulfate. Five animals from each group were euthanized at 30 and 45 days. The histomorphometry calculated the percentage of the new bone formation in the bone defect. Results: All data obtained were evaluated statistically considering P < .05 as statistically significant. The results demonstrated the potential of all biomaterials for enhancing bone regeneration. The findings showed no statistical differences between all the biomaterials at 30 and 45 days including the control group without bone grafting. Conclusion: In conclusion, the tested biomaterials presented an estimated capacity of osteoconduction, statistically nonsignificant between them. In addition, the selection of biomaterial should consider the specific clinical aspect, resorption rates, size of the particle, and desired bone healing responses. It is important to emphasize that in some cases, using no bone filler might provide comparable results with reduced cost and possible complications questioning the very frequent use of ridge presentation procedures. Schlagwörter: bone, bone substitutes, extraction, implants, wound healing

Orofacial pain is a worldwide pain problem, with many patients unable to find appropriate diagnosis and treatment. Orofacial pain includes pain arising from the odontogenic and nonodontogenic structures in the head and neck region. Dental clinicians need to have a thorough knowledge and skill to diagnose, manage, and treat patients with odontogenic pain or refer patients for treatment of nonodontogenic pain to specialists such as orofacial pain specialists, neurologists, otolaryngologists, and rheumatologists. More often, dental practitioners diagnose patients with a temporomandibular disorder (TMD), and when treatment is ineffective, term it “atypical facial pain.” The first requirement for effective treatment is an accurate diagnosis. Dental clinicians must be aware of giant cell arteritis (GCA), a chronic large-vessel vasculitis, primarily affecting adults over the age of 50 years, as it frequently mimics and is misdiagnosed as TMD. GCA is associated with loss of vision, and stroke and can be a life-threatening disorder. Therefore, diagnostic testing for GCA and differential diagnosis should be common knowledge in the armamentarium of all dental clinicians. Historically, temporal artery biopsy was considered the definitive diagnostic test for GCA. Temporal artery ultrasound (TAUSG), a safe and noninvasive imaging modality, has replaced the previous diagnostic gold standard for GCA, the temporal artery biopsy, owing to its enhanced diagnostic capabilities and safety profile. The present case report describes a patient with GCA, and the role TAUSG played in the diagnosis. Case report: A 72-year-old woman presented with left-sided facial pain, jaw claudication, dysesthesia of the tongue, and episodic loss of vision of 2 years’ duration. She was diagnosed with and treated for a myriad of dental conditions including endodontia and temporomandibular joint therapy with no benefit. A thorough history and physical examination, combined with serologic analysis, led to the diagnosis of GCA and TAUSG, which confirmed the diagnosis. Conclusion: This report underscores the responsibility of differential diagnosis and early recognition of GCA facilitated by TAUSG in optimizing treatment outcomes as a viable, noninvasive diagnostic tool. (Quintessence Int 2024;55:336–343; doi: 10.3290/j.qi.b4938419) Schlagwörter: diagnostic procedure, giant cell arteritis, headache, misdiagnosis, temporomandibular disorders